Ames 42"x75' Polyester Contouring Roof Fabric

Ames 42"x75' Polyester Contouring Roof Fabric

Ames 42"x75' Polyester Contouring Roof Fabric

SKUARLPS650
Quantity in stock 4 item(s) available
mpn LPS650
UPC 856955000035
Our price: $119.00
Quantity (4 available)
Ask a Question about this Product

Product Features

  • Ames 42"x75' Polyester Contouring Roof Fabric
  • Adds substantial strength to the coating of roof surfaces
  • Can be used over plywood, concrete, metal and many other surfaces
Ames 42" x 75' Polyester Contouring Roof Fabric adds substantial strength to the coating of roof surfaces. Roofing fabric is especially useful for roof decks and gutter areas.  May be used over plywood, concrete, metal and many other surfaces.
 
DO-IT-YOURSELF IN THREE EASY STEPS

Roofing fabric is normally set with Elasto-Barrier, but in special cases may be set with Snow Seal or Iron Coat.  Surface preparation is everything.  Prepare the roof by removing dirt, moss and other debris.  Power wash and let dry thoroughly.  Prime the roof smooth and apply seam tape and Elasto-Barrier to all joints and seams.


STEP 1: Starting at one end pour out a liberal amount of coating onto the surface.  Use a push broom or roller to spread the coating out in a path slightly wider than the roof fabric being used.  Roll the fabric into the wet coating until the coating comes up through the fabric and totally saturates it.  This is best done by laying the roll of fabric down and pushing it forward into the wet coating with the push broom or roller while the excess coating comes up through the fabric.  Avoid folds and wrinkles and use a liberal amount of coating.  The fabric will absorb almost two gallons per 100 sq ft.  Allow the surface to completely cure over night or 24 hours until complete adhesion has occurred.
 
STEP 2: With the roller or push broom, pull the excess coating off to the side in preparation for laying the next row of fabric.  Use the lap line on the fabric roll as a guide--you may butt or overlap the fabric.  If you choose to overlap the fabric, overlap its entire length by three to four inches, however overlaping may leave a seam.  Repeat this process until the entire surface is completely covered with fabric.  Allow to dry completely 24 to 48 hours.

STEP 3: To complete the roof fabric application process, apply an additional coat over the surface to completely seal and fill all remaining pinhole openings in the fabric.  The goal is to have all pinholes filled and no less than 30 mils of thickness (a dime).  The coating is best applied by pouring out and spreading.  Topcoat with Ames coating of choice according to label specifications.  Allow proper drying between coats.
There have been no reviews

Hard To Find Items_logo

FREE Shipping on Orders over $69. No Exclusions!